Plank your boat hull.
The art of boat building is an age-old craft requiring specialized skill, knowledge and expertise. For this reason, boat makers are often excellent woodworkers, understanding the structural integrity of various wood types. When the hull of a boat is created from wood they are often "planked" -- where long wooden planks are attached to the frame. Planking a boat hull may look easy or straight forward but can be tricky in getting the planks to meet flush at the ends. Flanking your hull can be done with the proper time and tools.
Instructions
Preparing the Planks
1. Measure the length of your planks to reach the full length of your boat's hull. Mark the length your plank should be.
2. Cut the planks to the appropriate length. Place each plank, one at a time, into the band saw. Saw across the width of the plank at your mark squaring each plank.
3. Place the square-edged plank face up on the saw bench marking the lap line -- where the plank lies flat against the surface.
4. Clamp the batten -- a small strip of wood -- to the lap line on the saw bench allowing the plank to be guided along the plane.
5. Plane the plank from the top of its face at approximately 12 feet to a feather edge -- a thin edge -- at the hood end of the plank.
6. Place unrabbeted wood stock at the transom -- flat surface at the boat's stern -- using the full thickness, mark the minimum rabbet depth onto the plank. The minimum depth occurs at the lap line. Plane the tapering rabbet to the depth determined at the transom.
Planking the Sides
7. Apply your first plank face up at the gunwale -- the upper edge of the side.
8. Shoot a single rivet into each plank at the connection point to the frame. Rivet the plank to the length of the boat.
9. Repeat Step 2 riveting each plank to the frame. This will create a "layered effect" -- placing each plank upon the next -- going down the frame. The layered planks will complete one side of the hull.
10. Repeat Steps 2 and 3 for the opposite side of the boat.
11. Halt the planking process when you are finished with both sides.
Planking the Bilge
12. Position the first plank from the bilge -- the bottom curves of the hull's underside -- to run along the bottom vertical edge called the "great circle."
13. Follow the same steps for laying the planks down the bilge.
14. Continue planking above and below the first plank on the bilge. Upon completion of planking the hull, clean and sheath the hull in glass cloth or wood veneer.
Related posts
Using pine tar, or Stockholm tar, as it's more commonly known, for caulking your boat can be tricky and time-consuming. What's more, not only is the process messy, so is the finished product--if y...
Cut your hair in sexy feathered layers.Styling your weave in a feathered layered cut is a sexy way to pay homage to the 1970's styles with sass. By adding hair extensions to your hair, you can cre...
Plastic flamingos serve as a good model for craft flamingos.Craft flamingos are popular decorative items these days. They are easy to make and you can individualize them with various colors and de...
Be on the front edge of fashion by making your own mini hat headband.The idea of a doll-sized hat on an adult might seem a little strange at first, but this trend is making its mark everywhere fro...
Decorate your cowboy hat with colorful embellishments and trimmings.According to Wild Wild Western Wear, John B. Stetson is credited with designing and marketing the first cowboy hat in the US in...
